Filter
Top Products
12
Installation
Cable
Cable
TV Setup
TV Setup
VCR Setup
VCR Setup
Connection 1
1. Connect the coaxial cable output on the cable box to the antenna input on
the TV.
2. Connect the coaxial cable from the wall to the input on the cable box.
3. Set the channel switch to 3 or 4 and then tune TV to the same channel
number.
Connection 2
1. Connect your cable input of the cable box.
2. Connect the audio/video output jacks on the cable box to the
corresponding input jacks on the TV, match the jack colors (Video = yellow,
Audio Left = white, and Audio Right = red).
3. Use the tv/video button on the remote control to select Video.
If connected to S-VIDEO on side panel, select the S-Video external input
source.
Important Note: If your cable box has Component Video outputs or DVI, it is
recommend you use those connections for the best quality picture.
High Definiton input on this LCD TV is only supported on these two
connections. When using DVI there are three connections to each device,
the DVI cable plus the two audio cables. When using Component there are
five connections to each device, the red, green, and blue video cables plus
the red and white audio cables.
VIDEO IN
DVD/DTV IN
RLVIDEO
P
R
P
B
Y
AUDIO(MONO)
H/P
+75 Ω
ANT IN
S-VIDEO
AC INPUT
PC
SOUND
PC INPUT
COMPONENT(480i/480p/720p/1080i)
OUT
IN
CH3 CH4
S-VIDEO
ANT IN
ANT OUT
(R) (L)
AUDIOVIDEO