Filter
Top Products
7
100 mm
100 mm
100
mm
100
mm
.
.
100 mm
100 mm
100
mm
100
mm
AV-S VIDEO L AUDIO R
PHOTOVIEWER
COMMON INTERFACE
–
+
Setup and cleaning
Only hold the housing for transporting and
never the panel.
The front panel and the LCD screen underneath
it are made of glass and may break if not
properly handled. If the LCD screen is damaged
(not the glass panel) and in case of leaking
liquid crystal, wear rubber gloves to carry the
device.
In case of contact with the skin, wash the
affected areas thoroughly with water.
Note
During the whole period of use, pixel errors
may appear on the screen in the form of lighter
or darker spots, this phenomenon is typical for
an LCD display. It is not a defect.
• Install the Spheros Signal Box and the
screen with room for air circulation. The air
vents may not be covered by objects such as
magazines, table cloths, curtains etc.
• Check the strength of furniture (e.g. tables,
sideboards) before placing the set on it.
•Take the swivel range into account when
installing a set with a rotary motor unit.
• Make sure no bright light or sunlight falls
onto the screen otherwise reflections will be
caused and the brilliance of the picture lost.
• Do not place the Signal Box on edge but on
its feet.
• Do not place naked flames, e.g. lit candles,
on the set.
Note on installing the flat screen (LCD):
Observe the enclosed installation instructions
depending on the type of set you have
purchased and installation.
With the Xelos SL 32 HD and 37 HD types a
stand (Xelos table stand) is usually delivered
for the LCD.
Handling the mesh tube
Use the enclosed mesh tube to lay the screen,
base, wall holder or rack cables tidily and guide
the hose with the cables to the Signal box. This
looks more elegant.
The diameter of the mesh tube widens when it
is pushed together lengthwise (see figure). This
makes it easier to push through the cables with
plugs.
Cleaning the front panel
(Only for Spheros 32/37 HD)
The inside of the front panel and the LCD
screen need to be cleaned from time to time.
Only remove the front panel when the TV has
been switched off and has cooled down. The
metal frame of the LCD panel may reach a
temperature of up to 60°C in operation !
• Hold the glass panel at the bottom right
and left and pull the panel out of the guide
about 4 cm.
• Push the glass panel up evenly.
• Unhook the glass panel at the top and
remove.
Use a damp, soft cloth to clean the LCD screen
and a glass cleaner for the glass panel.
Replacing the front panel:
• Make sure you do not damage the LCD
screen with the fastening bolts on the front
panel.
• Hang the glass panel into the guide rails at
the top with both fastening bolts.
•Then press the glass panel down lightly
onto the screen until it snaps into place.
Clean the other components such as the
remote control and signal box with a damp,
soft cloth only (without aggressive and
abrasive cleaning agents).
31963_021_RC3_GB 14.01.2005, 10:40 Uhr7