Loewe Connect 42 Full-HD+ 100 CRT Television User Manual


 
- 6
ANT OUT
(1
Connect antenna
output with ANT-TV
(tuner 1)
ANT-TV
Antenna/cable
analogue/digital
(Tuner 1)
mains switch
CONTROL
(1
- rotating stand control
(3
or IR link
(3
RS-232C
(1
- serial interface
AUDIO IN1 L/R - audio input left/right (analogue)
AUDIO OUT L/R - audio output left right (analogue)
ANT SAT2
(1
Satellite antenna
(Sat tuner 2)
ANT2
(1
Antenna/cable
analogue/digital
(Tuner 2)
AV1
Euro-AV
socket 1
AV2 (RGB)
Euro-AV
socket 2
220-240V~ 50/60Hz
mains connection
SERVICE - service socket
PC IN - VGA/XGA input
HDMI2 - HDMI (DVI) input 2
AUDIO DIGITAL IN - digital audio input
USB
(1
- USB connection 2 (USB stick/card reader)
SD/HD-COMPONENT IN Cb/Pb–Cr/Pr–Y - component video inputs
- Headphones
connection
CI - Common Interface
(CI-Slot)
AV-S -
S-VHS connection (AVS)
VIDEO IN - Video in (AVS)
AUDIO IN1 C - centre audio input (analogue)
AUDIO LINK
(1
- surround audio outputs (analogue)
HDMI1 - HDMI (DVI) input 1
USB - USB connection 1
(USB stick/card reader)
ANT SAT
(1
Satellite antenna
(Sat tuner 1)
AUDIO IN2 - audio input
AUDIO DIGITAL OUT - digital audio output
LAN
(2
-
network
connection
Connection for additional antenna
(2
HDMI 3
(1
-
HDMI (DVI) input 3
AUDIO IN - Audio in left /
right (AVS)
Connections rear side of the device – Connect 37 / Connect 42
Factory setting:
AV2: DVD recorder
You can change this during the
initial installation (page 12) or in
the connection wizard (page 44).
Before you connect other devices
or make any changes, please start
the connection wizard (page 44)
and the sound components wizard
(page 51), and then follow the
instructions that are displayed on
the TV set.
(1
See page 70/71 for equipment and upgrade possibilities.
(2
Only in sets with Network Mediaplayer (see operating manual Network Mediaplayer).
(3
Depending on which upgrade kit is used (see page 70/71).
Downloaded From TV-Manual.com Manuals