Filter
Top Products
- 12
First installation
If the reception conditions are good, then a room antenna may be used for
DVB-T. Passive and active room antennas are available on the market. The
power is supplied for an active antenna via the antenna connection. For
automatic programming or in "TV Menu – Connections – Antenna DVB –
Antenna DVB-T," the distribution voltage (5 volts) is to be set correspondingly.
It may be practical to use a nondirectional antenna. If the location is outside the
normal transmitting range, then a unidirectional antenna may also be used to
improve the reception quality.
You can fi nd out more on the digital stations that can be received in your area
at your specialist dealer.
If a Spheros R32/37 was retrofi tted with a PIP tuner or if this is already
integrated in a set with a digital recorder. The PIP tuner output has to be
connected with the ANT-TV socket (Tuner 1). See illustration on page 7.
If a Digital Satellite Tuner 1 has been retrofi tted, connect your satellite antenna
system to the ANT-SAT socket.
If a Digital Satellite Tuner 2 has been retrofi tted (only in conjunction with the
Digital Recorder+), then connect one antenna cable each, for example from the
antenna switch or from the twin LNC, to both SAT sockets.
When laying the cable, use the cable clips affi xed beneath the TV set.
Replace the connection cover on the TV set.
Handling the fabric hose
Use the fabric hose included to lay
the mains cables, antenna cables
or cables from other electronic
components systematically; then
lead the hose with the cables to
the connection boxes. This provides
you with an elegant solution when
laying cables.
The diameter of the fabric hose increases when you push it together lengthwise
(see illustration). This makes it easier for you to push through cables with plugs.
Using the common interface module
(only for sets with CI slot)
In order to be able to receive encrypted digital stations, the common interface
module (CI module) and the smartcard both have to be inserted into the
corresponding slot of your TV set. You can purchase the CI module and
smartcard at your specialist dealer. You can fi nd the slot on the back of your TV
set, see the illustration on pages 6/7.
1. Make sure the TV set is switched off with the mains switch on the set, or
pull the mains plugs.
2. First push the smartcard into the CI module as far as it will go. Insert it so
that the side with the golden
contact chip faces the side
of the module printed with
the supplier‘s brand logo.
Printed arrows indicate how
to insert the card. Also follow
the installation instructions
included with the smartcard.
3. Slide the CI module
(1
carefully into the slot with
the contact side facing the front. The logo on the
common interface module should be visible.
Make sure the module is not twisted in the process.
Do not use force.
When the module locks, the eject button is pressed
outwards.
(1
The CI module and the smartcard are not included in
the scope of delivery for this set; you can usually obtain
them at your specialist dealer.
Switching on
Press the mains switch (for Spheros R 37, the set switches on immediately, the
green indicator lamp lights up).
For Spheros R 26/32:
The red indicator on the set now lights up (standby mode).
Switch on the set using the switch integrated in the indicator
(for further operating options see page 14).
Contact side
COMMON INTER
FA
CE
Eject button
CI module
)