Filter
Top Products
29 -
You can remove certain stations from the programme
guide. These stations must be deactivated in the Station
selection. First, all stations for which programme infor-
mation can be provided are marked with a
. Stations
without a are not included in the programme guide.
Marking the stations according to reception ranges:
analogue stations via antenna/cable, for which the
current provider supplies data.
digital terrestrial stations DVB-T,
digital cable stations DVB-C,
digitale satellite stations DVB-S.
If you want to use EPG for analogue and digital stations,
select on (for DVB + analogue). If you want to use EPG
and only have DVB reception, select on (only for DVB).
If you are not using EPG and therefore do not want to
receive any EPG data, select off.
After making changes in the EPG menu, or each time the
mains switch has been switched off, the EPG data must
first be captured. To do this, switch on the device and
select (for analogue stations) the station that you have
defined as provider, and let the TV set run for about 1
hour with the selected station. Or switch the TV set to
standby mode. After 2 minutes the display on the TV
lights orange and the EPG data capture begins. When
the data capture process has concluded the display will
return to red. The data capture process is usually per-
formed between 2:00 am and 5:00 am, when the TV
set is in standby mode.
If the TV set is switched on, the TV set will switch over to
these stations, if there are any memorised programmes.
If the TV set is in standby mode when a memorised pro-
gramme begins, then you can specify here whether the
set should be turned on in this case. If you have set "yes"
in the menu, the TV set will be switched on. If you are
not in at the time, a safety prompt makes sure that the
TV switches off automatically after 5 minutes without
your acknowledgement.
Calling additional information about the programmes
➠ Brief information about many programmes is displayed
below the programme list of the broadcasts.
You can call detailed information with the TEXT button if
this function is offered by the TEXT icon in the lower
left.
Programming a recording for a recorder
➠ Selection is in the lower programme list,
if not, press the blue button.
6 Mark the desired programme.
Red button: Starts recording wizard.
Change or confirm timer data if necessary (see page 46,
the direct recording path).
Then a red dot will be displayed in front of this programme
as an identification.
Red button: Deletes the already programmed recording
of the red marked programme from the timer.
If the timer data have been transferred to an external
recorder, then the timer must also be deleted there.
Configuring EPG
Start the EPG menu
➠ EPG mode is started,
if not, press the EPG button.
Call the EPG menu.
Settings in the EPG menu:
Select provider, Station selection, Data capture, Switch on
TV when marked.
Explanations of setting possibilities in the EPG menu:
In analogue TV reception, there are possibly different
providers who broadcast the EPG data for certain sta-
tion packages. To get another range of stations, you can
change the provider with the Provider selection. If the
provider you are looking for is not in the list, then use the
yellow button to perform a Provider search.
The stations offered by the provider will be displayed
in a list.
Station
selection
Data capture
Switch on TV
when marked
Electronic Programme Guide
Select
Provider
END
INFO
OK
Select provider Select providerStation selection
EPG menu
Data capture
Switch on TV when marked