Filter
Top Products
9
First installation
Automatic programming
Automatic programming of the TV set is started the fi rst time you switch it
on. Follow the menus.
First you have to select the menu language. Then you enter which anten-
nae you have connected to your TV set and in what country you are using
it. Then start the station search. The TV set searches for, saves and sorts all
programs which are receivable on your antenna system.
Then log in your video equipment, decoder and Loewe audio system with
the co.nnection wizard and connect these to the TV according to the dis-
played connection diagram. If you want to connect other equipment later,
you will fi nd information from page 21 onwards.
By pressing the OK button in the direction of the arrow you
select the setting ...
... and confi rm your settings with OK. You then go to the
next menu.
You can repeat initial installation at any time, e.g. after moving house. Call
the index with the INFO button. Select the index item “Repeat initial opera-
tion“ (you will fi nd this listed separately before the letter A). Then start fi rst
time operation with OK.
Daily operation
OK
Switch on/off
Your TV is equipped with an eco-standby power supply unit. On standby
the power consumption drops to low power. If you want to save even more
electricity, switch the set off with the ON/Off button. However, please bear
in mind that EPG data will be lost and programmed timer recordings will
not be performed by the TV.
Switching off
If the TV is switched on, you can switch it off with the blue
on/off button on the remote control or with the display
field on the TV set on standby. The red lamp on the TV set
lights up. If it lights orange, a timed recording is made,
EPG data is entered or radio operation without screen
display is active.
Switching on the TV set
From standby it is best to switch back on with the blue
On/Off button or with a numeric key (station 0 – 9) of the
remote control.
Or use the switch integrated in the display on the set.
The display then lights green.
Or switch on the TV set with OK, you can see the station
table and select a station.
Switching on the radio
With the RADIO button on the remote control or ...
... with R on the operating ring on the TV set, you can
switch on radio operation.
The display no longer lights when you switch off the TV set with the On/Off
button on the left of the TV set.
If the TV set is switched off iln this way, you have to switch to standby
mode with the On/Off button fi rst and then switch on with the blue On/Off
button on the remote control or with the display window on the TV set.
OK
OK
)
)
)
RADIO