Filter
Top Products
page37
No sound
●
Check if the unit is connected securely.
●
Make sure the TV or amplifier is working properly.
●
Make sure the amplifier is set to receive DVD
signal output.
Bad sound quality
●
Make sure the audio output mode is set correctly.
●
Make sure the audio connection between the
unit and amplifier is in place.
No image
●
Check if the unit is connected securely.
●
Make sure the TV is working properly.
●
Make sure the color system is set correctly.
This product incorporates copyright protection technology that is protected by method claims of
certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and
other rights owners. Use of this copyright protection technology must be authorized by
Macrovision Corporation, and is intended for home and other limited viewing uses only unless
otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is
prohibited.
●
Remove barriers between the remote control
and the unit.
●
Point the remote control at the remote control
sensor of the unit.
●
Replace the batteries with new ones.
Remote control does not work
●
Disconnect the power plug and insert it into the
wall outlet again.
The unit doesn’t operate
normally
●
There is no disc in the unit.
●
Put the disc on the disc tray properly with the
label side up.
●
Clean the disc.
●
Moisture has condensed in the unit. Remove
the disc and leave the unit on for about an
hour.
Disc cannot be played
If you experience the following problems while using the unit, this troubleshooting guide can
help you.
TROUBLESHOOTING
__
WATCHING
DVD