Filter
Top Products
EXIT
1 OF 5
PICTURE
SOURCE
MORE...
CLOSED
CAPTIONS
FEATURE MENU
CHANNEL
MEMORY
CABLE
TUNING
MAIN MENU
PICTURE
FEATURES
SOUND
HELP
EXIT
EXIT
ADD/DELETE
CHANNELS
START
AUTO-PROGRAMMING
CHANNEL MEMORY
HELP
Channel 19 Added
for ANT A
to DELETE CHANNEL
when FINISHED
SELECT CHANNEL
M
ADD/DELETE CHANNEL
for ANT B
A
B
1ST TIME SETUP
213
546
879
0
TV
VCR
ACC
GUIDE
AV
INFO
SWAP PIP CH
UP
SOURCE FREEZE
SLEEP
AUTO
STATUS/
EXIT
VOL
CH
MUTE
SURF
100+
POWER
MENU/
SELECT
4
1
3
1
2
POSITION
DN
PIP
FEATURE MENU CONTROLS (CONTINUED)
A
uto-Programming (see
previous page) adds all the
channels it can find (on your
Antenna or Cable TV system) into
the TV's memory. Add/Delete
Channels makes it easy for you to
add other channels, or drop
unwanted channels, from the list of
channels in the TV's memory.
Select CHANNEL MEMORY
(ADD/DELETE CHANNELS)
control.
With the FEATURES MENU on
screen, move the RED highlight
with the outer MENU ring
buttons. Then press the center
MENU button to select the feature.
Press the CHANNEL ▲▼ or
number buttons to select the
channel you want to add or delete.
Press the outer MENU
ring button (on the Right) to
ADD the channel into the TV's
memory.
Press the outer MENU ring button
(on the Left) to DELETE the
channel from memory.
Repeat steps 2 and 3 for each
channel you wish to add or delete.
Press the STATUS or MENU
button to clear the screen when
through.
ADD/DELETE CHANNELS
STOP
1
2
3
4
SMART HELP
Remember. You can also
add the Auxiliary modes
(AUX 1 VIDEO, AUX 1 Y PB PR,
etc.) just like a channel. Then by
pressing the CHANNEL ▲▼
buttons the AUX(iliary) mode can
quickly be selected to use the
desired set of Input jacks (see
page 33).
Note: AUX(iliary) VIDEO modes
are located between the lowest
and highest channel numbers
within the ADD/DELETE
CHANNEL control screen.
BEGIN
NOTE: A separate ADD/DELETE CHANNEL memory
may also be created for the ANT(enna) B Input on the
rear of the set (if an Antenna or Cable TV signal has been
connected). Press the “AV” button on the remote, while
in the ADD/DELETE CHANNEL mode, to switch
between the ANT A and ANT B channel memory lists.
Then follow steps 2 and 3 as shown to the left to add or
delete the desired channels.
14