Filter
Top Products
Remote Locator 59
Your TV/VCR can find your remote control for you.
When you press the POWER button on the TV/VCR to turn on
the TV/VCR, your remote control beeps and LOCATING
REMOTE appears on the screen. The remote control will beep for
about 30 seconds. Or, press any button on the remote control to
stop the beeping.
If another remote control beeps...
The TV/VCR may find other remote controls. If this occurs, you
can program the TV/VCR to find only its remote control. Follow
the steps below.
1
Press the COMBI button, then press the MENU button.
2
Press the PLAY/▲ button or the STOP/▼ button to select
PRIM. SETUP, then press the F.FWD/B button.
3
Press the PLAY/▲ button or the STOP/▼ button to select
REMOTE LOCATOR, then press the F.FWD/B button.
4
Press the MUTE button, then press the PAUSE/STILL
button.
5
Press one Number button (0 - 9) to enter a single-digit code
for your remote control. Your remote control will beep briefly.
6
Press the STATUS/EXIT button.
YOUR REMOTE LOCATOR
CODE HAS BEEN CHANGED
NEW CODE IS 3
TO END PRESS EXIT
If another remote control beeps ...
YOUR REMOTE LOCATOR
CODE IS 4
PRESS ANY DIGIT
TO CHANGE CODE
TO END PRESS EXIT
PRESS MUTE THEN
PAUSE KEY
TO CHANGE CODE FROM 4
TO END PRESS EXIT
2-3
VAR.SLOW
CABLE/DBS
COMBI
VOL.
CH.
FM
3
6
9
SURF
0
2
5
8
1
4
7
TRACKING
F.ADV
SLEEP/WAKE UP
REC/OTR
POWER
SPEED
STATUS/EXIT
STOP
PLAY
F.FWDREW
MEMORY
SLOW
MUTE
VCR PLUS+
/ENTER
PICTURE
SKIP
SEARCH
INDEX
SEARCH
SOUND
EJECT
MENU
CLEAR
PAUSE/STILL
SMART
1
6
4
5
This device complies with part 15
of the FCC Rules. Operation is
subject to the following two condi-
tions: (1) This device may not
cause harmful interference, and (2)
this device must accept any inter-
ference received, including inter-
ference that may cause undesired
operation.
• The volume will be delayed while
the LOCATING REMOTE message
appears on the screen. Press the
STATUS/EXIT button to remove the
message and restore the volume.
Helpful Hint