Filter
Top Products
Basic Installation
Power
AC Power Swtich
1
. Connect TV Cable and Power Cord to this PDP TV
Set.
2. Plug Power Cord to your home power outlet.
3. Push the AC Power Switch to ON state.
4. Check front panel LED for proper power connection:
Blue color indicates this TV set is powered on;
Red color indicates this TV set is in standby state.
5. Push POWER KEY on Remote Control or Power key
on Front panel controls to switch the TV from stand
by state to ON state.
This TV will power on and you can see display on
screen within a few minutes.
6. Once you see information displayed on screen, press
SOURCE button on Remote Control or MODE key on
front panel continuously to select TV as input
source. TV channel information will be displayed.
7. Use
Auto channel search
in “Setup Menu” to search
all channels in your location. Refer to page 8 for
“Setup Menu” operation procedure.
8. After
Auto channel search
is completed, press
“
CH+”
or “CH–” key on remote control to select the nex
t
lower or higher channel.
Refer to the following pages for operatin
g
procedures:
y Remote Control – page 7.
y Setup Menu – page 8.
y TV Channel Arrangement – page 11.
POWER KEY
Ch14.0 12:00AM
TV channel information
6