Filter
Top Products
7
EN
Before Using
Information on Digital Broadcasting
Digital terrestrial
antenna
Digital
terrestrial signals
STB (Set Top Box)
converts the ATSC signal
to analog signal
TV
Receives
ATS C
ATS C
This STB makes it possible to view the digital TV
programs on your analog TV by converting the
digital signal to the analog signal. You can use
most features provided by the digital broadcast,
except that the resolution of the image is always
output in 480i (standard resolution).
Accessories
Check the following accessories when unpacking the STB:
Remote control:
NA386UD (x1)
Owner’s manual:
1VMN25976 (x1)
AA battery (x2) RF cable:
WPZ0901TM002 /
WPZ0901TM005 (x1)
Installing Batteries
Instalación de pilas
1 Unsnap the battery cover from the
back of the remote control.
Abra la cubierta de pilas de la parte
trasera del mando a distancia.
2 Install two AA batteries making
sure the polarity (+ /
-
) is correct.
Instale dos pilas AA asegurándose que
la polaridad (+ /
-
) sea la correcta.
3 Snap the battery
cover back.
Cierre la cubierta de
pilas.
CAUTION:
Do not mix battery types (alkaline and manganese, or old ones and
new ones).
No mezcle tipos de baterías (baterías alcalinas y de manganeso, ni pilas viejas
con pilas nuevas).
Do not recharge, short-circuit, heat, burn or disassemble batteries.
No recargue, caliente, queme o desarme baterías ni provoque un corto circuito
con ellas.
Remove batteries from battery compartment that is not going to be
used for a month or more.
Quite las pilas del compartimento de pilas si no se va a utilizar durante un mes o más.
•
•
•
NOTE:
When replacing batteries,
replace them in pairs.
Cuando cambie las pilas,
hágalo por pares.
•
X6042UD_TB100MW9.indd 7X6042UD_TB100MW9.indd 7 2008/05/29 14:26:192008/05/29 14:26:19