1
Make the connections shown above.
32 Rerecording (Tape Duplication)
3
VCR 2 will record your tape. Insert a blank tape in VCR 2. The
VCR must be in VCR position. (The VCR/TV light will appear on the
display panel. If it does not, press the VCR/TV button once.)
4
Turn on the TV and set it to channel 03 or 04, whichever
channel the CH3/CH4 switch on VCR 2 is set to.
5
Point the remote control at VCR 2. Press the Number
buttons 0, 0, 1 or 0, 0, 2. (See Helpful Hints at right.)
6
Press the SPEED button to select SP or SLP at VCR 2.
7
Press the PLAY button on VCR 1 and the REC(ord)/OTR
button on VCR 2 at the same time.
To stop recording, press the STOP/EJECT button on VCR 1, then
press the STOP/EJECT button on VCR 2.
CH3 CH4
OUT
IN
ANT
AUDIO
R
L
VIDEO
OUT
IN
INOUT
CH3 CH4
OUT
IN
ANT
R
L
VIDEO
IN
OUT
IN
OUT
AUDIO
VCR 1
Playing VCR
VCR 2 - Recording VCR
2
VCR 1 will play your tape. Put a prerecorded tape in VCR 1.
1. Audio cables from AUDIO OUT Jacks
of VCR 1 to AUDIO IN Jacks of VCR 2
2. Video cable from VIDEO OUT Jack
of VCR 1 to VIDEO IN Jack of VCR 2
3. RF coaxial cable
from the OUT jack of
VCR 2 to the TV’s
ANTENNA IN Jack
• If you use the AUDIO and VIDEO IN
Jacks on the back of VCR 2, press
Number buttons 0, 0, 1 at step 5.
AV REAR will appear on the screen.
• If you use the AUDIO and VIDEO In
Jacks on the front of VCR 2, press
Number buttons 0, 0, 2 at step 5.
AV FRONT will appear on the
screen.
• Unauthorized recording of copyright-
ed television programs, video tapes,
or other materials may infringe on
the rights of copyright owners and
violate copyright laws.
• If a program has copyright protec-
tion, it may not record clearly.
• These instructions show you how to
copy tapes using two VCRs like
yours. Different VCRs may operate
differently.
• The VCR in the figure above is the
VR601BMX. If you have the
VR401BMX, use a single-plug audio
cable to connect the AUDIO OUT
jack on VCR 1 to the AUDIO IN jack
on VCR 2.
Helpful Hints
● Audio and Video cables are not supplied.
The instructions on this page show you how to copy tapes. The illustration uses two VR601BMX VCRs.
Different VCRs may operate differently. To duplicate a tape, make the connections shown, then follow steps 1-7.