Filter
Top Products
7
Cutting, sawing and scraping
CAUTION:
• Do not move on the tool forcibly in the direction
(e.g. towards either side) of tool application with
no cutting edge. It may damage the tool.
013856
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE:
• Forcing or excessive pressure on the tool may
reduce efficiency.
• Remove sawdust by drawing tool adequately. It
increases work efficiency.
• Before cutting operation, it is recommended to
preset the orbital stroke rate 3 - 5.
• The round saw is recommended for cutting long
straight line.
Sanding
CAUTION:
• Do not reuse a sanding paper used for sanding
metal to sand wood.
• Do not use a worn sanding paper or sanding
paper without grit.
013857
Apply a sanding paper on the workpiece.
NOTE:
• Using a test material sample to try is
recommendable to determine a correct orbital
stroke rate suitable for your work.
• Use a sanding paper with the same grit until
sanding the whole workpiece is completed.
Replacing a sanding paper with different grit
sanding paper may not get a fine finish.
Dust extraction attachment
(optional accessory)
1
2
3
4
5
6
7
013858
1
1
2
3
013052
1. Nozzle band
2. Protrusions
3. Holes
1. Joint
2. Nozzle band
3. Dust nozzle
4. Dust attachment
5. Felt ring
6. Pad
7. Holder bolt