Filter
Top Products
33
CHAP. 6 Network Setup
1) Static IP
User input IP address in IP CONFIG SETUP which is assigned from ISP company.
1. Verify if IP address is OK or not with PC before connecting DVR.
2. Connect LAN cable to DVR after confirmation.
3. DVR : MENU Æ EXTERNAL DEVICE Æ TCP/IP
4. Set DHCP to MANUAL and go into TCP/IP SETUP.
5. Verify if MAC ADDRESS starts from 00-0A-A2….
6. Input IP address which is assigned from ISP company.
7. Set IP PORT. (50000 recommended)
8. Input GATEWAY which is assigned from ISP company.
9. Input SUBNET MASK which is assigned from ISP company.
10. Go out of MENU SETUP.
11. Turn off and on Modem (Router) which is provided by ISP company.
Æ This is to reset client of MAC from ISP company.
User have to wait for 30 seconds after turning on.
12. Access DVR with Remote Viewer software.
* If user fail to access, please verify 1, 6, 7, 8, 9, 11 again.
* When speed is too slow and connection fails after access : MENU Æ EXTERNAL
DEVICE Æ TCP/IP SETUP Æ CONNECTION SETUP
Increase value of Timeout to find the most suitable speed.
Remote Viewer
(Client)
Internet (Static IP)
DVMR
(Server)