Memorex DVD2050-RWP DVD Player User Manual


 
8
CONNECTION
CONNECTING THE DVD TO A TV USING THE
AUDIO/VIDEO OUTPUT JACKS
Audio Cable (Included)
Video Cable (Included)
From
Video Out
From
A
udio
O
ut
To
Audio In
To
Video In
CONNECTING THE DVD TO A TV USING THE
S-VIDEO OUTPUT JACK
Audio Cable (Included)
S
-Video Cable (Not Included)
F
rom
S-Video Out
From
Audio
O
ut
T
o
A
udio In
To S-Video In
NOTES FOR CONNECTING TO A TV:
If your TV has an S-Video input, connect the DVD player with
the S-Video cable for best results.
Set the TV’s TV/VIDEO button or switch to the VIDEO setting.
When connecting the DVD, refer to the owner’s manual of the
TV, as well as this manual.
When connecting the DVD to the TV, make sure the power is off
and both units are unplugged before making any connections.
If your TV only has one audio input, the use of a “Y” connector
may be necessary. Visit your local electronics supply store.
Connect the DVD player to your TV directly. If you connect the
DVD player through a VCR, the playback picture will be
distorted because DVD video discs are copy protected.
CONNECTING THE DVD TO A HOME THEATRE SYSTEM
1
3
2
9
5
4
6
78
Coaxial Cable (Not Included)
To Digital
Audio Input
From
Digital Out
From
Video Out
To Video
Input
Video Cable (Included)
Place the subwoofer, front, rear and center speakers in locations as
shown/described here. After correctly positioning the speakers, perform
the Tone Test on the AV Amplifier and adjust the volume controls until the
desired sound is achieved. For best results, sit in the viewing position
and have someone adjust the volumes for you; this will enable you to set
the optimal levels.
NOTE:The rear speakers can also be located on the side wall facing the
viewing position and each other. Make sure the viewing position is located
between the 2 speakers in this case. Experiment to find optimal position.
NOTES FOR CONNECTING T
O
ATV:
If your TV has an S-Video input, connect the DVD player with
S-Video cable for best results.
Set the TV’s TV/VIDEO button or switch to the VIDEO setting.
When connecting the DVD, refer to the owner
s manual for the
TV and the audio system, as well as this manual.
When connecting, make sure the power is of
f and all units are
unplugged before making any connections.
Connect the DVD player to your
TV directly. If you connect the
DVD player through a VCR, the playback picture will be
distorted because DVD video discs are copy protected.
If using a
TV with a blue screen option, turn the option of
f, on
the
TV for best results.
If you place the DVD player near a tuner, the radio broadcast
sound might be distorted. In this case, move the DVD player
away from the tuner
.
1. Front Left Speaker
2. Television
3. Center Speaker–can be located
on top or below the Television.
4.
Sub-woofer–
can be located
anywhere in the room.
5. Front Right Speaker
6. Viewing/Listening Position–
The
best listening position is obtained
by positioning the chair, sofa, etc.
in the middle of all the speakers.
7. Rear Left Speaker
8.
Rear Right Speaker
9. AV Amplifier w/Dolby Digital
Decoder/DTS Decoder