Filter
Top Products
6
Converter/
Descrambler
A
B
Converter/
Descrambler
A
/
B SwitchSplitter
300-75 ohm
Matching Transformer
(not supplied)
Combiner
(not supplied)
300-75 ohm
Matching Transformer
(not supplied)
VHF Antenna
Incoming CATV
Single 75 ohm Cable
Combination VHF/UHF Antenna
300 ohm Twin-lead Wire
Splitter
Take off the Splitter
Single 75 ohm Cable
300 ohm Twin-lead Wire
300 ohm Twin-lead Wire
UHF Antenna
ANT.
This television has an extended tuning range and
can tune most cable channels without using a cable
company supplied converter box. Some cable
companies offer "premium pay channels" in which
the signal is scrambled. Descrambling these
signals for normal viewing requires the use of a
descrambler device which is generally provided by
the cable company.
ANTENNA/CATV CONNECTIONS
For Subscribers to Basic Cable TV Service
For basic cable service not requiring a Converter/
Descrambler box, connect the CATV 75 ohm Coaxial Cable
directly to the Antenna Jack on the back of the television.
For Subscribers to Scrambled Cable TV Service
If you subscribe to a cable service which requires the use of
a Converter/Descrambler box, connect the incoming cable
to the Converter/Descrambler box and connect the output of
the box to the Antenna Jack on the back of the television.
Follow the connections shown left. Set the television to the
output of the Converter/Descrambler box (usually channel 3
or 4) and use the Converter/Descrambler box to select
channels.
For Subscribers to Unscrambled Basic Cable with
Scrambled Premium Channels
If you subscribe to a cable service in which basic cable
channels are unscrambled and premium channels require
the use of a Converter/Descrambler box, you may wish to
use a two-set signal splitter (sometimes called a "two-set
coupler") and an A/B Switch box from the cable installer or
an electronics supply store. Follow the connections shown
left. With the switch in the "B" position, you can directly tune
any nonscrambled channels on your TV. With the switch in
the "A" position, tune your TV to the output of the Converter/
Descrambler box (usually channel 3 or 4) and use the box
to tune scrambled channels.
Combination VHF/UHF Antenna (Single 75 ohm Cable
or 300 ohm Twin-lead Wire)
Connect the 75 ohm cable from a combination VHF/UHF an-
tenna to the Antenna Jack. If your combination antenna has a
300 ohm Twin-lead Wire, use the 300-75 ohm Matching
Transformer (not supplied).
Combination VHF/UHF Antenna (Separate VHF and UHF
300 ohm Twin-leads)
Connect the UHF Twin-lead Wire to a Combiner (not
supplied). Connect the VHF Twin-lead to the 300-75 ohm
Matching Transformer (not supplied). Attach the Transformer
to the Combiner. Attach the Combiner to the Antenna Jack.
Separate VHF/UHF Antennas
Connect the 75 ohm Cable from the VHF antenna and the
UHF antenna Twin-lead to a combiner (not supplied). Attach
the Combiner to the Antenna Jack.
NOTE: If your VHF antenna has a Twin-lead Wire, use the
300-75 ohm Matching Transformer (not supplied), then
connect the Transformer to the Combiner.
3K00701B-E 18/08/2001, 14:546