Filter
Top Products
NOTES:
TV, VCR, and CBL Device Codes can be searched and locked into "CBL" & "AUX" modes. Simply
press "CBL" or "AUX" Device Mode Button in step 2 and enter an appropriate Magic Search Code to start
searching.
Each time you press the "VOL+" button, the TEK PARTNER
TM
will skip to the next code. Then press
the "PWR" button to send out a POWER signal trying to turn off your device.
If you failed to stop pressing "VOL+" in time when your device has been turned off, turn on your device
again immediately. Before the indicator goes out, press "VOL-" on the TEK PARTNER
TM
to skip
backward. Repeat step 4 above and lock in the code.
If the power on/off function of your device is not infra-red controlled, you need to follow steps 1 thru 3
above and start searching: Press "VOL+" and another important function button alternately until your
device responds to the expected function, press the same device mode button again to lock in the code. e.g.
Press "VOL+" & "1 " alternately, or; Press "VOL+" & "PLAY" alternately until the device responds.
OPERATING THE TEK PARTNER
TM
NORMAL OPERATION
Once you have set up the TEK PARTNER
TM
for your equipment, it works like your original remote
controls. To operate, just aim it at your equipment, press an appropriate Device Mode Button and then
command the desired function by pressing a corresponding button on the TEK PARTNER
TM
. The indicator
flashes during signal transmission and as confirmation of button touch. At your button touch, your TEK
PARTNER
TM
illuminates the keypad for 4 seconds. You may see the keypad clearly even when you are
operating your equipment in a dimly lit area.
PUNCH THROUGH
Punch through allows you to operate your TV’s volume and mute functions and your VCR’s 6 tape
management functions without having to switch the device modes repeatedly even when your TEK
PARTNER
TM
is in other operating modes.
MAINTENANCE
1. Do not expose your TEK PARTNER
TM
to direct sunlight, high temperature, mechanical shock, or
liquids.
2. Do not use old and new batteries together as old batteries tend to leak.
3. Do not use corrosive or abrasive cleansers on your TEK PARTNER
TM
.
4. Keep the unit dust free by wiping it with a soft, dry cloth.
5. Do not disassemble your TEK PARTNER
TM
, it contains no user-serviceable parts.
TROUBLE SHOOTING
Q. My TEK PARTNER
TM
does not work at all!
A. If your device’s main switch is turned off, the TEK PARTNER
TM
can not operate the device.
A. Check whether batteries are in good condition, inserted properly, and are in correct +/- polarity. See
HOW TO INSTALL THE BATTERIES.