Filter
Top Products
www.midxtc.com
3
English François
Recording
1. Move the RECORD switch forward. This turns the camera on.
2. The battery indicator will light from red to green. The SD card indicator
will light green. The record indictor will begin ashing red after 8
seconds. This indicates the camera is capturing video.
3. To stop recording, move the RECORD switch back to the off position.
Note: The camera will continue recording for 3 seconds after toggling the
switch to the off position.
SD card LED
Status
Meaning
Green 1 GB or more available.
Orange 512 MB to1 GB available.
Red
Below 512 MB available or
no micro SD card installed.
Flashing Red Cannot read the card.
Flashing Green Indicates card has been reformatted.
Memory Size Record Time
512 MB 7.5 Minutes
1 GB 15 Minutes
2 GB 30 Minutes
4 GB 60 Minutes
8 GB 120 Minutes
16 GB 240 Minutes
32 GB 480 Minutes
Note: The camera automatically splits the video into 2 GB
segments.
Getting to Know the XTC-100/150
Getting to Know the XTC-100/150
Batteries
1. To insert the batteries, push down the battery door latch on the
right side of the camera. Door will release. Push forward to
remove.
2. Install 2 AAA batteries observing polarity.
3. Return battery door and click into place.
*Note: We recommend using Lithium batteries in cold weather.
Micro SD Card
1. Open and fold down the back rubber cover.
2. Insert Micro SD card into slot observing proper direction (shown below).
3. Return rubber ap into place.
Battery Status
Indicator
Meaning
Solid Green Indicates full battery life
Solid Red Indicates half battery life
Blinking Red* Indicates low battery life
No Light Batteries are dead
*Note: When the red battery LED begins blinking, be prepared
to change the batteries because the camera will stop recording
at this point.
**Note: Quality of battery directly effects the record time.