Mitsubishi Electronics 154 Series Flat Panel Television User Manual


 
86 Appendices
For assistance call 1(800) 332-2119
Reset Name When to Use How to Use Resulting Action
A/V Reset
(for all inputs)
To reset audio and
video adjustments for
all inputs to the original
factory settings.
While viewing the TV, press the
control-panel buttons
INPUT
and
VOLUME DOWN
at the same time for at
least two seconds.
All Audio and Video settings are
returned to the original factory
settings, including global settings
not affected by Picture > Reset.
Channel
Memorization
To erase and
re-memorize channels
on the
ANT
input.
While viewing the TV, press 1.
MENU
to display the main menu.
Navigate to the 2. Setup >
Channel menu.
Highlight the reception mode, 3.
e.g. Ant Air.
Select 4. All channels.
Highlight 5. Scan.
Press 6.
ENTER
to start channel
memorization.
All previously memorized chan-
nels for the antenna input are
erased and a new set of memo-
rized channels is created. To
add or delete individual channels,
see the Setup > Channel > Edit
menu instructions on page 53.
Lock Menu
Pass Code
To change your Lock
menu pass code
See the
cutout page from Appendix B,
page 79.
Allows establishment of a new
code.
Control-Panel
Lock Release
To re-enable the
control-panel buttons
after activation of the
Control-Panel Lock
Press and hold the
INPUT
button on
the control panel for ten seconds. If
the TV is powered off, you can then
press the
POWER
button to turn it on.
Allows the control panel to be
unlocked if the remote control is
misplaced.
Auto Input
Sensing for
HDMI
If the New Device
Found screen does
not appear when you
connect an HDMI
device.
Disconnect the HDMI device.1.
Delete the HDMI input in the 2.
Inputs > Name menu (see page
55).
Power on and connect the new 3.
device.
The New Device Found screen
will display.
System Reset If the TV does not turn
on or off, does not
respond to the remote
control or control-
panel buttons, or has
audio but no video.
Press and hold the
POWER
button on
the control panel for ten seconds.
The TV will turn off. Power on the
TV and the green LED will flash
quickly for about one minute. The
changes you made most recently,
before using
SYSTEM RESET
, may
be lost.
TV Reset
IMPORTANT:
Use this reset
only if other
troubleshooting
has been unsuc-
cessful.
To reset all consumer-
accessible settings
and all memories to
the original factory
defaults.
Use TV Reset if the TV
can respond to con-
trols but TV behavior is
abnormal.
CAUTION: All owner-
performed setups and
adjustments will be
erased.
While viewing the TV, press 1.
MENU
to display the TV main
menu.
With the main menu displayed, 2.
press number keys 1 2 3 to
display the Reset menu.
READ THE ON-SCREEN 3.
WARNING AND INSTRUC-
TIONS.
If you do not wish to use this •
reset, press
EXIT
or
MENU
to
back out.
If you do wish to use the •
reset, press
ENTER
to erase
all memories and settings.
The TV will start the initialization
process and then turn off.
Power on the TV and the front
green LED will start flashing. All
memory and settings outlined in
this Owner’s Guide will need to
be set again.
Appendix E: Troubleshooting, continued
Downloaded From TV-Manual.com Manuals