Filter
Top Products
For assistance call 1(800) 332-2119
5
Battery Installation
Emitter
1
2
1. Remove the cover.
2. Insert the battery, positive side up. Be sure the
retaining clip holds the battery securely.
3. Reinstall the cover.
To remove the battery,
press on the
retaining clip.
The remote control requires one CR2025 lithium battery.
3D Adapter
IR Sensor
POWER
Light Lit when power is on.
3D STATUS
Light Lit during 3D signal processing.
POWER
Button
Allows manual override of auto on/off. Press to power
off the Adapter if it powers on when not needed,
3D MODE
Button Allows manual selection of 3D format conversion.
Controls and Indicators
POWER
3D MODE
POWER
POWER
3D MODE
3D STATUS
Adapter
Remote Control
Lithium Battery Safety
This product uses CR2025 Li/MnO2 lithium coin batteries.
WARNING: Lithium coin cell batteries pose a serious risk of injury if ingested.
Keep cells out of reach of children. If ingested immediately contact a physi-
cian or the National Poison Center at 202-625-3333.
CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type (CR2025).
CAUTION: Risk of fire and burns. Do not recharge, disassemble, heat above
100
˚
C (212
˚
F), or incinerate. Keep battery out of reach of children.
Disposal. Dispose of used batteries promptly according to local recycling or
waste regulations.