Filter
Top Products
MITSUBISHI IP (Security Products)
4
a valid IP address (greater than 255). Therefore you need to change the second digit
the number “9” first.
Step 3. Once all changes have been made, press the SETUP Button for about 2 seconds to
APPLY the new changes. The unit will Turn-Off and back ON. The DVR will come-up
in its ready state. No other changes are needed at this time
2.
Configure the computer:
The following example is based on the Windows 2000 operating system. Other operating systems such as
UNIX, Linux, Macintosh, Windows XP, NT, Me, 98, 95 etc. should have the same capabilities but in a
different formats. Please consult your operating system’s manual.
Connect a CAT 5 network cable to the OfficePortal 1800 HW .
Turn on the OfficePortal 1800 HW
Turn on the computer.
From the Windows Desktop, select
Start Æ Settings Æ Control Panel Æ Network and Dial-up connections
Right click “Local Area Connection”, select “Properties”
select Internet Protocol (TCP/IP)
If you don’t see this option then you can
click the “Install…” button below, then
“Protocol” Æ “Add…” Æ “Microsoft”
Æ Internet Protocol(TCP/IP)
Then select Properties