Mitsubishi Electronics LX10 Universal Remote User Manual


 
27
CHAPTER 3 BEFORE USING I/O MODULE
3
3.3 I/O Combined Module
3.3 I/O Combined Module
This section describes the precautions for using the I/O combined module.
The precautions not described below are common to that for the input module and output module. ( Page 20,
Section 3.1, Page 21, Section 3.2)
(1) I/O numbers of the I/O combined module
The I/O combined module uses same I/O number for input and output.
Because same number is used for input and output, the I/O numbers to be used can be saved.
(2) Applicable software
Use GX Works2 with version 1.492N or later.
The following cannot be set using GX Developer and GX Works2 whose version is earlier than 1.492N.
"I/O Mix" cannot be selected in I/O Assignment.
Input response time cannot be set.
Error Time Output Mode cannot be set.
Input (X) Output (Y)
X00
X1F
Y00
Y1F
32 points