Filter
Top Products
63
CHAPTER 6 INSTALLATION AND WIRING
6
6.2 Wiring
(3) Removal procedure for the terminal block
(4) Installation procedure for the terminal block
1. Open the terminal cover and loosen the terminal
block mounting screw.
2. Press the terminal block fixing holes until the lower
part of the terminal block is disengaged from the
module, and then remove the terminal block.
1. Fully insert the projections on the top of the
terminal block into the terminal block fixing holes
and press the terminal block until it snaps into
place.
2. Open the terminal cover and tighten the terminal
block mounting screw.
Terminal block
mounting screw
Terminal block fixing hole
Terminal block
mounting screw