Mitsubishi Electronics LY28S1A Universal Remote User Manual


 
65
CHAPTER 6 INSTALLATION AND WIRING
6
6.2 Wiring
(3) Wiring method for the 40-pin connector
For the wiring method, refer to the following.
MELSEC-L CPU Module User's Manual (Hardware Design, Maintenance and Inspection)
(4) Installing procedure for the 40-pin connector.
(5) Removal procedure for the 40-pin connector
1. Plugging the connector
Plug the wired connector into the slot on the I/O module.
2. Tightening the connector screws
Tighten the two connector screws (M2.6).
1. Disconnecting the connector
Loosen the two connector screws and pull out the
connector from the module.
Connector screw