Mitsubishi Electronics WS-73905 Projection Television User Manual


 
77
IMPORTANT
IMPORTANT
Store your Diamond Shield
TM
carefully
so that the shield does not become
scratched.
The custom-fitted Diamond Shield is an extra protection for your television screen. It has a subtle
tint that enhances picture contrast. It can be removed or installed, according to your preference.
Wear cotton gloves to prevent putting fingerprints on the Diamond Shield.
Removal of the Diamond Shield:
• to remove put a small piece of masking tape on the outward
side of the Diamond Shield. This will designate the special
scratch resistant side for later use
remove the retaining clips (2) with a small, flat blade screwdriver.
Press blade into opening at end of clips (Illustrations 1or 2) and
pry out
after loosening retaining clip ends, gently pull out to remove clips
gently pull Diamond Shield towards you, bowing the shield out of
its locking channels (Illustration 3 or 4)
reinstall the retaining clips (2), if desired
Installation of the Diamond Shield:
remove the retaining clips (2) with a small, flat blade screwdriver.
Press blade into opening at end of clips (Illustrations 1 or 2) and
pry out
after loosening clip ends, gently pull out to remove clips
Bow Diamond Shield towards you and insert into locking chan-
nels (Illustrations 3 or 4)
press in provided retaining clips (2) into place at ends first, then
towards center
• your Diamond Shield is now installed
Appendix 1- Diamond Shield
TM