Mitsubishi Electronics VS-50805 Projection Television User Manual


 
83
Appendix 4 - INPUT-3 Video Connection Compatiblity
INPUT-3 Component Video connection compatibility
This input is compatible with component video signals from standard DVD players and other
equipment that send standard NTSC component video, also known as 480i. This input may also be
compatible with some newer DVD players, that are described as 480p or progressive scan. Since
the industry standard concerning copy protection for 480p DVD signals was not finalized when this
TV design was completed, you may experience a small amount of picture disturbance near the top
edge when playing discs using the 480p outputs of some DVD players.
Input levels and timing with component video
Y = 1.0V p-p (includes sync) 75 ohms
Cr = 700m Vp-p,75 ohms
(can also recieve signals from outputs labeled R-Y and Pr).
Cb= 700m Vp-p, 75 ohms (can also receive signals from outputs labeled B-Y and Pb).
HIGH DEFINITION INTERFACE HDTV Video connection compatibility
This input is fully compatible with the Mitsubishi HD-1080 HDTV receiver. You will need BNC-to-
RCA adaptors for the RGB with H and V cable connections to the TV. Adaptors are available at
most electronic and computer supply stores.
For other HDTV receivers, this input is compatible with most standard HDTV receivers that have
component video outputs. Compatible DTV signals are SDTV 480i or 480p and HDTV 1080i. All
other digital TV signals, such as 720p, need to be converted by the HDTV receiver to any of the
above signals. Please check the HDTV receiver specifications before connecting.
This input is also compatible with HDTV receivers using RGB with “sync on green” or RGB with
“separate H and V sync”. Compatible DTV signals are SDTV 480i, 480p or HDTV 1080i. All other
digital TV signals, such as 720p, need to be converted by the HDTV receiver to one of the compat-
ible signals. Industry standards for DTV RGB signals systems, synchronization and signal strengths
are not currently established. These inputs will not be compatible with all HDTV receivers that
offer RGB. If your HDTV receiver offers both HDTV component video signals and HDTV RGB
signals, Mitsubishi suggests you use the HDTV component video signals. Please check the HDTV
receiver specifications before connecting.
Input levels and timing when used with HD component video signals
EIA - 770.3 standard levels and timing
Y = 1.0Vp-p (includes sync), 75 ohms
Pr = 700m Vp-p, 75 ohms
Pb = 700m Vp-p, 75 ohms
H = not used
V = not used
Input levels and timing when used with RGB
G (Y) = 1.0Vp-p 75 ohms (compatible with sync on green)
R (Pr) = 700mVp-p, 75 ohms
B (Pb) = 700m Vp-p, 75 ohms
H = 3Vp-p
+ 1.0v, 75 ohms (when using separate H and V sync)
V = 3 Vp-p
+ 1.0v, 75 ohms (when using separate H and V sync)