Filter
Top Products
Page 38
MODELS: WD-52627 / 52628 / 62627 / 62628 / 62827 / 62927 / 73727 / 73827 / 73927
DIAMOND SHIELD REPLACEMENT
(WD-62927 / WD-73927 Only)
To Remove the Diamond Shield:
1) While wearing soft cotton gloves,
loosen the sides of the Diamond Shield
by pressing a small plastic card (the
size of a standard credit card or a
clean, plastic, putty knife) into the
middle of the side slot. The Diamond
Shield side will snap out of the top,
middle and bottom clips. Loosen both
sides before proceeding to step 2.
2) After the sides are free, gently push
down on the top of the Diamond
Shield. It will slide out of the top
channel.
3) Carefully pull the screen up to it from
the bottom channel. Store the Diamond
Shield in a clean dust free area, where
it will not be scratched.
To Install the Diamond Shield:
4) Slide the Diamond Shield into the bottom
channel, making sure it fits securely.
5) Press gently on the top of the Diamond
Shield to slightly bow the screen toward
you. Insert the top of the Diamond Shield
into the top channel. It should fit securely.
6) At each side, gently press the top, middel
and bottom of the Diamond Shield to snap it
back into place.
WARNING
Sharp edges! Always wear gloves to handle, lift,
install and remove the Diamond Shield.