Filter
Top Products
27
27
TV
AUDIO
CABLE/DBS/DTV DVD
VCR
1
2
POWER
Code to enter:
To reset to default code, enter 000
DVD/LDP brand
Mitsubishi (DVD)
Mitsubishi (LDP)
Panasonic
Pioneer DVD (LDP)
Sony
Toshiba
003
016, 017
250
252 (016, 017)
254
253
If your
DVD
code is not
listed here,
please see
page 62
for a
complete
listing.
DVD/LDP Player Codes
3
Figure 4. Programming the remote to control your DVD/
LDP.
1
2
POWER
Code to enter:
To reset to default code, enter 000
Audio brand
Mitsubishi A/V receiver
and/or CD player
Denon
Kenwood
JVC
Onkyo
Pioneer
Sony
Yamaha
Set M-VR1000 or M-VR800 to 015
Set M-VR900 or M-VR700 to 010
234, 235, 236
200, 208
232, 233
209, 214
205, 207
222
201, 202
If your
audio
code is not
listed here,
please see
page 62
for a
complete
listing.
A/V Receiver Codes
3
TV
AUDIO
CABLE/DBS/DTV DVD
VCR
Figure 5. Programming the remote to control your A/V
receiver.
If the slide switch is set to TV when
you enter an A/V receiver code, VOLUME
and MUTE will control the A/V receiver
rather than the TV. To return volume
and mute control to the TV, set the slide
switch to TV, press and hold POWER
and enter 000.
Some manufacturers may change their
products, or they may use more than
one remote control system. If this is the
case, your remote control may not be
able to operate your VCR, DVD, cable
box, satellite receiver, or A/V receiver.
Part III: Setup
Programming the Remote Control: To Control Other A/V Products
After entering the correct codes in each posi-
tion of the remote control, use the slide
switch to select which product will respond
when an operational button is pressed. If
you enter a code from the AUDIO chart
while the slide switch is set to TV, the
volume and mute functions change to match
the A/V receiver. This is useful when using
an A/V receiver with the TV all the time.
In all other cases, only one of the below
devices is allowed for each slide switch posi-
tion.
TV position:
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
VCR position:
VCR
DVD position:
DVD
LD Player
Audio position:
A/V receiver
Mitsubishi CD player [If you have a Mitsubishi A/V
receiver, the audio position may be used in conjunction with
select Mitsubishi CD players. Your audio position must be
programmed to either 010 or 011. Plug the CD player power
cord into a switched outlet on the back of your A/V receiver.
Pressing the POWER button will then turn on your A/V receiver,
in turn, turning on your CD player. On select CD players, the
transport controls (FF, Play, Rew, etc.) in the audio position will
operate the CD player.]
Programming the Remote Control: To Control Other A/V Products