Filter
Top Products
34
35
NetCommand
®
Initial Setup, continued
Review Screen
Figure 4
After you have made your device choices, the Review
Screen will display. It is important to review the
settings to ensure that they are correct. If necessary,
you can use <Back to return to the Device Setup
screen to make changes.
Figure 4. Review screen
Finish Screen
Figure 5
To complete the NetCommand setup, select Finish
from the Finish screen.
If you wish to change any of the pre-defined inputs
or names for the devices, or add devices not in
the pre-defined setup, select Edit to display Edit
NetCommand menu.
If your A/V Receiver was not listed, select Edit to
assign all devices to new AVR inputs.
It is still necessary to memorize the available
channels for Antenna-1 (and Antenna-2, if used).
You may do that by going to the TV Main menu
and selecting Antenna. Instructions to memorize
channels are found in the Antenna menu section.
Figure 5. Finish screen
Note: The Review screen lists the TV input and
A/V Receiver input used with each device. You
must correctly identify the inputs you used when
you connected the devices. If you have not
connected your devices, write down these inputs
as a guide. If you cannot use these inputs, or if
you would like to change the name of a device,
use the instructions in Edit NetCommand to make
necessary changes.
Note: If you select Next> on the Review screen,
all selections are finalized.
On the Review Screen, adding or deleting check marks
will turn the adjacent devices or inputs On or Off. 1394
device names only appear on the Review screen when
the devices are connected to the TV.