Mitsumi electronic WD-73733 Flat Panel Television User Manual


 
25
TV Operation and Features
4
Choosing a Viewing Source
Input Selection menu
ChooseaviewingsourcefromtheInput Selection
menu.ThecurrentTVinputappearsasafull-coloricon
inthismenu.
1. Press
INPUT
todisplaytheInput Selectionmenu.If
thereareonlytwoinputstotheTV,
INPUT
switches
betweenthemwithoutdisplayingthemenu.
2. Highlightaninputiconusing .
3. Press
ENTER
toswitchtotheinputandclosethe
menu.
More About the Input Selection Menu
• Toassignmeaningfulnamestotheicons,seethe
Inputs > Namemenuinchapter5,“TVMenuSet-
tings.”
• Torearrangetheicons,seetheInputs > Order
menuinchapter5,“TVMenuSettings.”
Sleep Timer
TheSleepTimerturnstheTVoffafterthelengthoftime
youset.
Setting the Sleep Timer
1. Press
SLEEP
ontheremotecontrol.
2. Press
SLEEP
additionaltimestoincreasethetimein
30-minuteincrementsuptothemaximumof120
minutes.
3. Press
EXIT
orwaitfivesecondswithoutpressingany
buttonsforthemessagetodisappear.
4. Press
SLEEP
toviewthetimeremainingbeforethe
sleeptimerturnsofftheTV.
Cancelling the Sleep Timer
1. Press
SLEEP
todisplaytheon-screenmessage.
2. Press
SLEEP
repeatedlyuntilOFF isdisplayed.
Note: Aftervesecondsofinactivity,themessagebox
willdisappear.
TV Tips
Turning the TV On or Off
ToturntheTVonoroff,pointtheremotecontrolatthe
frontoftheTVandpressthe
POWER
button.Alterna-
tively,pressthe
POWER
buttononthefrontpanelofthe
TV.
If You Turn Off the TV by Mistake
1. Press
POWER
againwithinabout30seconds,while
thelampisstillhot,tohavetheTVcomebackon
immediately.
2. Ifthe
LAMP
indicatorstartsblinking(about30
secondsafteryoushutoffpower),wait about one
minute for the
LAMP
indicator to stop blinking
and press
POWER
to turn the TV on again.
Controlling Sound Volume
Press
VOL
/ toadjustthesoundlevel.
Seealso
“ControllingA/VReceiverSoundVolume”inchapter2,
“TVSetup.”
Changing Channels (antenna sources)
Tochangechannels:
• Enterthechannelnumberusingthenumberkeys
ontheremotecontrolandpress
ENTER
.Foratwo-
partdigitalchannel,suchas3-1,press
3
CANCEL
1
toenteradash(separator).
• Press
CH
/ tochangechannelsonechannelat
atime.
• Pressandhold
CH
/ tomovequicklythrough
channels.
• Press
QV
(QuickView)toswitchbacktotheprevi-
ouslytunedchannel.
• Press
GUIDE
todisplayChannelViewchannellistings,
highlightachannel,andpress
ENTER
.
• UsetheFAV(Favorites)featuretosetuplistsof
favoritechannelsandtunetothemwiththe
FAV
key.
See“SetupMenu”inchapter5.
NOTE: Memorizechannelstomakendingchannels
easier.SeetheSetup > Scanmenu.