Filter
Top Products
10
Installing the Wall Plate
continued
Masonry Mounting
Masonry mounting requires specialized knowledge, skills
and tools. Monster highly recommends that you seek the
help of a professional installer when mounting to masonry.
DO NOT drill holes in masonry mortar joints.
With the help of a friend, position the mounting plate
in the desired location.
Using the provided level, confi rm
that the wall plate is plumb or vertically straight.
For best results, position the level horizontally
with the narrow end fl ush against the side
of the wall plate. Hold the plate fi rmly in place.
Mark the centers of the top and bottom mounting holes
with a pencil. Be careful not to mark a mortar joint.
With your electrical drill and 1/2" masonry bit, pre-drill
a 3" deep hole at each mark.
Install the supplied plastic anchors in each hole.
Tap into hole until fully seated.
Attach the wall plate to the wall using the lag bolts
and round washers as shown to the right.
DO NOT over tighten bolts. This can damage
the wall plate or the surface of your wall.
1)
2)
3)
4)
5)
6)