Filter
Top Products
22
Routing Your TV’s Power Cord and AV Cable
through the Cable Management System
With the mount completely installed on the wall
and your TV properly secured to the mount,
fully extend the mount’s swing arms.
Swing the mount completely to the left or right.
This enables you to slide off the cable management
covers on all three swing arms.
Connect your TV’s power cord to the TV (if TV uses
a detachable-type power cord).
Slide the cable management covers off the swing
arms, as shown to the right.
Route your TV’s power cord through the left
cable channel.
Route AV cable from your wall, set-top box, AV receiver,
or other source through the right channel and second
arm, as shown to the right and make connections to
your TV.
Slide the cable management covers back into place.
Screw on the second arm’s cover. Replace the end cap.
1)
2)
3)
4)
5)
6)
7)