Filter
Top Products
Attaching the Vertical Adjustment Bars to the TV
DO NOT lay your TV face down when attaching the Vertical
Adjustment Bars. This can cause permanent damage
to your screen. Lean it against a wall or other solid surface
so it remains vertically upright.
Your TV should be unplugged before threading any bolt
or screw into the back panel.
Your mounting system features 12 sets of screws of varying diameter
and length. Before attaching the adjustment bars to your display, determine
which screw set is correct for your display.
TVs with fl at backs use a shorter screw without a spacer. TVs with curved backs
or recessed inserts may require a longer screw with a spacer between the TV
and adjustment bars. Smaller M4, M5 or M6 screws require a square washer
(supplied) between the adjustment bar and each screw.
Locate the threaded inserts on your TV’s back panel. Thread a screw
from the set into one of the inserts to ensure it is the correct choice.
Thread screws through the adjustment bars into the TV inserts with the
appropriate spacer and washer set, if needed.
With a Phillips screwdriver, tighten the screws so the adjustment bars
are fi rmly attached to the TV.
DO NOT over tighten screws. Thread screws carefully by hand before
tightening. If you feel any resistance, remove the screw immediately.
1)
2)
3)
12