Filter
Top Products
17
2. Start a terminal emulation program (TEP).
3. Connect your computer to a mini USB or RJ-45 console port on
the front panel of the blade.
4. Configure the TEP to use the following settings:
• Baud rate. 115200 bps
• Data bits. 8
• Parity. None
• Stop bit. 1
• Flow control. None
5. Type the show network command and press the Enter key.
A screen displays that shows the active switch IP address.
6. Connect your computer to one of the numbered ports on the
switch’s front panel.
7. On the computer that is connected to the switch, enter the
switch IP address in the address field of a browser.