Filter
Top Products
66
6
Troubleshooting
Troubleshooting
Symptom Probable cause Action
Nothing appears on
the display
The batteries are not loaded properly.
Verify that the batteries’ polarities =
and - are correct (☞ P.10).
Battery power is getting low.
Replace with new batteries (☞ P.10).
The power is off.
Turn the power on (☞ P.13).
Won’t start
Battery power is getting low.
Replace with new batteries (☞ P.10).
The power is off.
Turn the power on (☞ P.13).
The recorder is in HOLD mode.
Release the recorder from HOLD
(☞ P.14).
Unable to record
Low remaining memory.
Erase unnecessary files (☞ P.34).
The maximum number of files has
been reached.
Change to the another folder
(☞ P.18 to P.21).
No playback tone
heard
The earphone is connected.
Unplug the earphones to use the
internal speaker.
The volume level is set to [00].
Adjust the volume level (☞ P.27).
Recording level too
low
The microphone sensitivity is too low.
Set the microphone sensitivity to the
conference mode and try again (☞
P.23 or P.36, P.38).
This could potentially be because
the output level for the connected
external devices are too low.
Adjust the output level for the
connected devices.
Voice files are not
recorded in stereo
The connected external microphone
is monaural.
When recording while an external
monaural microphone is connected,
sound will only be recorded by the
L-channe l.
[Rec Mode] is set to a monaural
recording mode.
Set [Rec Mode] to the stereo
recording mode (☞ P.36, P.38).
Cannot find the
recorded Voice File
Wrong folder.
Switch to the correct folder
(☞ P.18 to P.21).
Noise heard during
playback
The recorder was shaken during
recording.
--------
The recorder was placed near a cell
phone or fluorescent lamp while
recording or during playback.
Move the recorder.