Omnimount G304 TV Video Accessories User Manual


  Open as PDF
of 2
 
Step 1
Install hex screw into pads on bottom of back post. (Fig. 1a)
Install cable port covers into back post. (Fig. 1b)
Fig. 1a
Fig. 1b
Step 2
Install shelf retention screws into flange at rear of shelves. (Fig. 2a)
Note: Set screw should be flush with bracket. (Fig. 2b)
Install shelf pad on flange. (Fig. 2b)
Model: G303 & G304
Fig. 2a
Fig. 2b
Step 3
Install end caps into foot sections on front of base frame. (Fig. 3)
Fig. 3a
Step 4
Secure shelf frames to back post with long hex bolts, using supplied hex wrench.
Note: It is easiest to begin with base shelf.
Rock the stand to check that it is level and stable.
Note: For unstable condition, un-screw shortest leveling foot until table sits level.
Step 5
Attach adhesive pads to corners of each shelf. (Fig. 5)
Fig. 4
Step 6
Insert rear of glass shelves into retention brackets, and tighten retention screw with screw-
driver. (Fig. 6)
DO NOT OVER TIGHTEN
Fig. 5
Fig. 6
 previous