Filter
Top Products
8
Testing the Code for Maximum Functionality
1. Try a variety of the device’s functions with the remote. If
some features of your devices don’t work, go to the next
step to try a different code.
2. Repeat the Manual Code Search and Entry Method from
the beginning. When the device turns off for the first time,
don’t press the OK key, which would store the same code.
Instead, with the unit now off, continue to press the SKIP
FWD key repeatedly until the unit turns back on.
3. Once the unit turns back on, you have found another code
that operates the device. Press the OK key.
4. Test the key’s functionality again by trying a variety of
functions. If the code controls the majority of the device’s
functions, programming is complete. If the code stored
does not give maximum functionality, try another code.
NOTES
Throughout the programming of each key, keep the remote
pointed at the IR sensor of the device you are programming
the remote to control.
Test the remote with the device to make sure the device
key is programmed with the correct code for maximum
functionality. If some features don’t work, try a different
code. See the “Testing the Code for Maximum Functionality”
section below for more information.
During the Manual Code Search, the remote ignores
keypresses that aren’t part of the search.
The search times out after two minutes (the POWER key blinks
four times and the last programmed code under that device
key is retained).
The POWER key blinks four times when the remote has gone
through all the codes. The remote exits the Manual Code
Search. If your device hasn’t turned off yet, try a different
search method.