Filter
Top Products
5 WWW.ONEFORALL.COM
The RECEIVER can be interfered with an external RF signal. The LED (A/B) of
the RECEIVER will blink even without pressing a key on the remote control.
If this is the case, please try the below:
1. Try to move the RECEIVER.
2. Reduce the antenna length.
3. Set the switch to position “C”.
Interference
Your RECEIVER is also the recharging-station for the included (2/3 AAA size) battery.
If your remote control is functioning at a shorter distance than normally (when the LED
(A/B) of the RECEIVER does not blink when a key on the remote control is being pressed)
then the battery needs to be recharged.
1. Remove the (2/3 AAA size) battery from your remote control.
2. Place the (2/3 AAA size) battery in the compartment that you can find on the bottom
of the RECEIVER. The LED (BAT) will light up.
3. The LED will switch off as soon as the (2/3 AAA size) battery is fully charged.
NOTE: The RF operating range may vary depending on the overall battery charge (e.g.
you may have to replace the alkaline batteries if the operating range decreases).
Caution: Use only with supplied rechargeable battery. Risk of explosion if battery is
installed by an incorrect type.
Recharging the (2/3 AAA size) Battery
Safety precautions
SV1100_IR-Receiver.qxd 27-07-2006 09:05 Pagina 7