Filter
Top Products
3. Press DVD/VCR once, then press AUX once.
The
LED will blink twice.
4. The AUX key is now ready to be set up to
control your second DVD player.See
Programming Device Control on page 9.
To re-assign other device keys to the
AUX key,repeat
steps 1 through 4 with a sequence from the below chart:
NOTE: Only one device can be assigned to an unused device
key at a time.
To Re-Assign Device Perform Sequence
AUX as 2nd TV key: SET - 9 - 9 - 2 - TV - AUX
AUX
as 2nd CBL/SAT key: SET - 9 - 9 - 2 - CBL/SAT - AUX
When a re-assignment is done,the LED will blink twice
to confirm your choice.At that time,you will need to
program the remote control for the new device (see
Programming Device Control on page 9).
USING CHANNEL SCAN
In the DVD/VCR,CBL/SAT,or TV mode,use the FAV key to
start a 3-second scan of all channels.If programmed,
use the
FAV key to scan only your favorite channels to
view a desired channel (see Programming Favorite
Channel Scan on next page.)
1. If Favorite Channel Scan has been set up,
skip to step 2.Otherwise, press
DVD/VCR,
CBL/SAT,or TV once.
2. Press
FAV once.
•IfFavorite Channel Scan has been set up,
scanning of favorite channels will start
and cycle through stored channels for
3 minutes or until stopped by pressing
any key.
•IfFavorite Channel Scan has not been
set up,scanning will start with the
current channel,then proceed to the
next channel up and cycle through all
channels for 3 minutes or until stopped
by pressing any key.
3. To stop scanning channels at any time,
press any key once.
15
IMPVE4P manual 1.0 4/11/03 4:34 PM Page 15