One for All URC-7711 Universal Remote User Manual


 
Search method
--> If your device does not respond to the ONE FOR ALL 1 after you
have tried all the codes listed for your brand.
--> If your brand is not listed at all.
The Search Method allows you to scan through all the codes contained
in the memory of the ONE FOR ALL 1.
To search for your television code:
1. Switch your television on (not in standby).
2. Press and hold down MAGIC until the ONE FOR ALL
1 red light blinks twice (the red light will blink once
then twice).
3. Press 9 9 1. The red light will blink twice.
4. Next, press POWER.
5. Aim the ONE FOR ALL 1 at your Television. Now press
CH+ over and over, until your Television turns off
(every time you press the CH+ key the ONE FOR ALL 1
will send out a POWER signal from the next code
contained in the memory). You may have to press
this key many times (up to 150 times) so please
be patient.
If you skip past a code, you can go to the previous
code(s) by pressing the CH- key. Remember to keep
pointing the ONE FOR ALL 1 at your Television while
pressing this key.
6. As soon as your television turns off, press MAGIC to
store the code.
- Most TV’s do not switch on pressing the POWER key. Please try pressing
a “number” key or the “TV-text off” key to switch your TV back on.
- If you cannot control your Television properly, please continue the
Search Method, you may be using the wrong Code.
WWW.ON EFORALL. COM 7
Setting up the ONE FOR AL L 1
CH
704995_URC-7711_S-10:URC-7710 TANGO 1 Scand-grieks 27-02-2007 11:44 Pagina 7