Onkyo DV-SP503E DVD Player User Manual


 
11
Before Using the DV-SP503E
Notes:
The supplied batteries should last for about six
months, although this will vary with usage.
If the remote controller doesnt work reliably, try
replacing both batteries.
Dont mix new and old batteries, or different types of
batteries.
If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage
and corrosion.
Flat batteries should be removed as soon as possible to
prevent possible leakage and corrosion.
To use the remote controller, point it at the DV-SP503Es
remote control sensor, as shown below.
Notes:
The remote controller may not work reliably if the
DV-SP503E is subjected to bright light, such as direct
sunlight or inverter-type uorescent lights. Keep this
in mind when installing the DV-SP503E.
If another remote controller of the same type is used in
the same room, or the DV-SP503E is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.
Dont put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
The remote controller may not work reliably if the
DV-SP503E is installed in a rack behind colored glass
doors. Keep this in mind when installing the DV-
SP503E.
The remote controller will not work if theres an obsta-
cle between it and the DV-SP503Es remote control
sensor.
Installing the Batteries
1
Open the battery compartment, as shown.
2
Insert the two supplied batteries (AA) in
accordance with the polarity diagram
inside the battery compartment.
3
Close the battery compartment.
Using the Remote Controller
R
E
T
U
R
N
S
E
T
U
P
T
O
P
M
E
N
U
M
E
N
U
C
U
R
S
O
R
P
U
S
H
T
O
E
N
T
E
R
D
V
-
S
P
5
0
3
E
S
U
P
E
R
A
U
D
I
O
C
D
&
D
V
D
A
U
D
I
O
/
V
I
D
E
O
P
L
A
Y
E
R
P
R
O
G
R
E
S
S
I
V
E
S
C
A
N
P
R
O
G
R
E
S
S
I
V
E
30˚
30˚
Approx. 16 ft. (5 m)
Remote control sensor
DV-SP503E