Filter
Top Products
15
Before Using the DV-CP701
Notes:
• The supplied batteries should last for about six months,
although this will vary with usage.
• If the remote controller doesn’t work reliably, try replacing
both batteries.
• Don’t mix new and old batteries, or different types of bat-
teries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage and
corrosion.
• Flat batteries should be removed as soon as possible to pre-
vent possible leakage and corrosion.
To use the remote controller, point it at the DV-CP701’s
remote control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the DV-
CP701 is subjected to bright light, such as direct sunlight
or inverter-type fluorescent lights. Keep this in mind when
installing the DV-CP701.
• If another remote controller of the same type is used in the
same room, or the DV-CP701 is installed close to equip-
ment that uses infrared rays, the remote controller may not
work reliably.
• Don’t put anything, such as a book, on the remote control-
ler, because the buttons may be pressed inadvertently,
thereby draining the batteries.
• The remote controller may not work reliably if the DV-
CP701 is installed in a rack behind colored glass doors.
Keep this in mind when installing the DV-CP701.
• The remote controller will not work if there’s an obstacle
between it and the DV-CP701’s remote control sensor.
Installing the Remote Controller’s
Batteries
1
Open the battery compartment, as shown.
2
Insert the two supplied batteries (AA) in
accordance with the polarity diagram inside
the battery compartment.
3
Close the battery compartment.
Using the Remote Controller
30˚
30˚
DV-CP701
Remote control sensor
Approx. 16 ft. (5 m)