Filter
Top Products
35
2. For each station, compare the station’s
guide channel number with the number
you select on the TV or VCR to tune to the
station. If the numbers match, cross that
station off of the list.
3. If a tape is playing, press
STOP
.
4. Press
MENU
to display the main menu.
5. Repeatedly press
PLAY
or
STOP
to highlight
SET
UP
CHANNEL
, then press
FF
.
6. Repeatedly press
PLAY
or
STOP
to high-
light
VCR Plus+
CH
SET
UP
, then press
FF
.
The following appears on the TV screen if
you selected a cable box or DSS receiver
as your input source.
The following appears on the TV screen if
you selected an external antenna as your
input source.
7. Press
PLAY
or
STOP
to highlight the guide
channel you want to set, then press
FF
. The
cursor moves to the right of the guide
channel you selected.
8. Repeatedly press
PLAY
or
STOP
to select a
CATV
CH
or
TV
CH
number. Then press
REW
to set the number.
9. Repeat Steps 7 and 8 for each remaining
channel number.
If the channel number is not correct, re-
peatedly press
PLAY
or
STOP
then
FF
to
select the correct number. Then press
PLAY
or
STOP
to change the number or
ADD/DLT
to delete it.
10. When you finish, press
MENU
three times
to exit.
Timer Recording with VCR Plus+
Most television guides list a 1- to 8-digit num-
ber called a PlusCode next to many of the
listed programs. You can use these PlusCodes
to easily program your VCR to record broad-
casts.
You can set the VCR to record as many as
eight broadcasts, including any timer programs
you want to set up (see “Automatic Timer Re-
cording” on Page 37).
You can set the VCR to record at any time on a
specific day, at the same time each week, or
the same time Monday through Friday.
Before you start, be sure you have set the VCR
Plus+ guide channels for your area (see “Set-
ting the VCR Plus+ Guide Channels” on
Page 34).
Note:
The VCR can record only one broadcast
at a time. If you schedule recording of broad-
casts on different channels that start at the
same time, the VCR records the lowest timer
number. For more information about timer
numbers, see “Setting a Timer” on Page 38.
1. Turn on the TV and set it to the same chan-
nel as the VCR’s
3 CH. 4
switch.
Note:
If you are using a TV/monitor that is
connected to the VCR’s
R-AUDIO-L/VIDEO
OUT
jacks, set it to the video mode.
2. Insert a blank cassette, or one that you
want to record over, into the VCR. The
VCR turns on.
3. Repeatedly press
TV/VCR
until VCR
appears.
H
SET UP
C
ATV
C
H
Y
--
--
SET
:
KEY
SELE
C
T
:
KEY
VCR P
l
u
s
+
C
H SET UP
GU
I
DE
CH
TV
C
H
END
:
M
E
NU
KEY
0
1
0
2
--
--
16-551.fm Page 35 Tuesday, July 20, 1999 5:13 PM