Sylvania 6420FMG CRT Television User Manual


 
MENU
VOLUME
HANNEL
POWER
MENU
VOLUME
CHANNEL
POWER
PREPARATION FOR USE
CONNECTIONS
ANT.
AUDIO
VIDEO
ANT.
IN
OUT
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO
WIDE SLOT, FULLY INSERT.
ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA
PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET
POUSSER JUSQU’AU FOND.
[EXTERNAL CONNECTION]
AUDIO/VIDEO input
AUDIO
VIDEO
Audio Cable
Video Cable
Video GameVideo Camera
Rear of this TV
Notes:
If you press [GAME] when the TV is off, the TV turns on and enters in Game mode.
If you adjust another picture control while in Game mode, this mode will automatically
be canceled.
ex.
Plug the incoming cable into the ANT. jack on the rear of the TV.
OPERATIONS
Note:
If some digits appear in the corner of the screen when the unit is turned on for the first time,
press [POWER] without unplugging the power cord.
Infrared Sensor Window
POWER button
To turn TV on/off
CHANNEL /buttons
To select channels
VOLUME
XX
/
YY
buttons
To adjust volume
MENU button
To view on-screen menu
INSTALLING THE BATTERIES
Install two AAA batteries (not supplied)
matching the polarity indicated inside
battery compartment of the remote
control.
[BATTERY PRECAUTIONS]
Be sure to follow the correct polarity as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
Do not mix different types of batteries together (e.g. Alkaline and Carbon-Zinc) or old batteries
with fresh ones.
If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
2
1
3
SELECTING AUDIO/VIDEO INPUT
You can select external input jacks by pressing [GAME] on the remote control.
1
1
GAME
GAME
To use external input
Picture: GAME (ON)
Input:
External
2
2
15
To return to TV channel
GAME
In the Game mode, you can use input jacks with suitable picture adjustments for video games.
(OUT)
(IN)
(IN)
(OUT)
2
2
[-]
GAME MODE
[+]
OFF ON
VIDEO
To cancel Game mode only
3
3
Picture: Customized
Input: External
15
To return to TV channel
GAME
MENU
m
VOL
You can enter into Video mode from Game mode by adjusting a Picture control.
2 times
1
1
GAME
GAME
To use external input
Picture: GAME (ON)
Input:
External
Select “PICTURE”
Note:
For your safety and to avoid damages to the unit, unplug the antenna cable from the
ANT. jack before moving the unit.
After 10 seconds
*Note (DO NOT DISCONNECT FROM BOX)
Some cable TV systems use scrambled signals and
require a special converter to receive these channels.
Consult your local cable company.
OR
Incoming cable from home Antenna /
Cable Company (No Cable Box)
Incoming cable from Cable
Company or Satellite Antenna
Cable Box or
Satellite Box*
Cable
TV signal
Antenna
Rear of this TV
OR
Cables not included
Note:
You can test if the remote control sends out the infrared signal with an AM radio.
(Refer to “TROUBLESHOOTING GUIDE”.)
SELECTING AUDIO/VIDEO INPUT
You can select external input jacks by pressing [GAME] on the remote control.
Notes:
In case no channel can be received by the channel scanning, “NO TV SIGNALS” is displayed on
the screen. Turn off the unit and check the antenna connection, then follow step 1 again.
If those settings do not work properly, please call our help line on the front page of this owner's manual.
2
2
If the TV screen shows
snow noise and there
is no operation for
more than 10 seconds,
“HELPFUL HINTS”
appears. Follow the
instructions listed on
the screen.
1
1
Select the desired
language according to
the screen indication.
After that, the TV
performs “AUTO
PRESET CH” to scan
channels available for
the broadcasting in
your area.
When the scanning is completed, or [MENU] is pressed during channel scanning to cancel it, the
tuner stops on the lowest memorized channel.
- HELPFUL HINTS -
1.PLEASE CHECK TO SEE IF
THE ANTENNA/CABLE/
SATELLITE IS PROPERLY
CONNECTED.
2.DID YOU PERFORM
“AUTO PRESET CH” ?
3.PLEASE REFER TO FRONT
PAGE OF THE OWNER’S
MANUAL OR REAR PANEL
FOR SUPPORT LINE
INFORMATION.
SELECT LANGUAGE
ENGLISH
NEXT:PRESS CH
K
ESPAÑOL
DESPUÉS:PRESIONE CH
L
FRANÇAIS
APRÈS:PRESSEZ VOL
K
– INITIAL SETUP –
PLEASE CONNECT ANTENNA
OR CABLE OR SATELLITE
TO THIS UNIT.
THEN PRESS CH
K
,
IN ORDER TO PERFORM
“AUTO PRESET CH”.
INITIAL SETUP
When you turn on the power for the first time, the “SELECT LANGUAGE” menu is displayed.
The “INITIAL SETUP” menu is displayed every time you turn on the unit unless the scanning is
completed.
REMOTE CONTROL AND FRONT PANEL FUNCTION
123
456
789
0
+100
MENU
o
n
p
m
MUTE SLEEP
DISPLAY
CH RET
GAME
POWER
CH
VOL
POWER button
To turn TV on/off
Channel number buttons
Press two digits to directly access the
desired channel. Remember to press
a "0" before a single digit channel.
CH
KK
/
LL
buttons
To select channels and move
up/down through menu items
MENU button
To view on-screen menu
SLEEP button
To set Sleep Timer
DISPLAY button
To display CH No./Audio Status
CH RET button
To return to previous channel
GAME button
Press to set the Game mode.
MUTE button
To mute sound
VOL
XX
/
YY
buttons
To adjust volume
To decide the command of settings
IR transmitter
To send infrared ray (IR) signal
+100 button
Press to select cable channels
higher than 99.
L3319UV_EN.QX4 06.7.5 10:05 AM Page 2