Sylvania LD190SS1 Flat Panel Television User Manual


 
43
EN
INTRODUCTION
PREPARATION
WATCHING TV
OPTIONAL SETTING OPERATING DVD
DVD SETTING
TROUBLESHOOTING INFORMATION
EnglishEspañol Français
Stereo Sound Mode
Stereo Sound Mode
CD
This unit allows you to select a sound mode during CD playback.
During playback, press [AUDIO] repeatedly until the
desired sound mode appears.
STEREO
Each time you press [AUDIO], the sound mode
changes as example below.
STEREO (stereo sound with left and
right channels)
L-ch (left channel sound only)
R-ch (right channel sound only)
Note:
Virtual surround cannot be changed when the sound mode
is set to either “L-ch” or “R-ch”.
Virtual Surround
Virtual Surround
You can enjoy virtual surround on your 2 channel stereo system.
1
During playback, press [MODE] repeatedly until “
appears.
OFF
(
SURROUND
)
2
Press [Cursor K / L] to select the sound level.
or
1
(
SURROUND
)
1 : Natural effect.
2 : Emphasized effect.
OFF : No effects (original sound).
3
Press [BACK] to exit.
Note:
The setting will be kept even if the unit is turned off.
For audio CD, virtual surround will not be effective if the
sound mode is set to something other than “STEREO”.
Refer to “Stereo Sound Mode” on page 43.
Turn down the level or select “OFF” if the sound is distorted.
Marker Setup
Marker Setup
This feature allows you to assign a specific point on a disc to be called back later.
To set a marker
1
During playback, press [MODE] repeatedly until
” / “ ” appears.
e.g.) DVD
_ _ /12 (SEARCH)
2
Use [Cursor K / L] repeatedly until marker search
menu appears.
or
123456789
10
AC
3
Use [Cursor
s
/
B
] to select an available marker within
60 seconds.
123456789
10
AC
4
When the playback reaches the point at which you
want to set a marker, press [ENTER].
Marker is now set.
23456789
10
AC
5
Press [BACK] to exit.
To return to the marker later
1
Repeat steps 1-2 in “To set a marker”.
Use [Cursor
s
/
B
]
to select the desired marker.
e.g.) DVD
23456789
10
AC
2
Press [ENTER] at the desired marker to restart playback
from the specific point which you set.
23456789
10
AC
Note:
Marker search menu will disappear in about 60 seconds
when there is no input.
You can mark up to 10 points.
To clear a marker, select the marker to be cleared, and then
press [CLEAR].
Ejecting the disc or turning off the power will erase all
markers.
• Selecting “ ” at step 3 in the section “To set a marker” will
also erase all markers.