Sylvania SRC21194 TV VCR Combo User Manual


 
- 17 - EN
9I03
PLAYBACK
NORMAL PLAYBACK
Make sure ...
TV/VCR power must be turned on.
1 Insert a prerecorded tape
If the erase-protection tab has been removed, the
TV/VCR will start playback automatically.
2 To begin playback
Press the PLAY button.
Note: If any menu is activated on
the screen, the PLAY button does
not function. Press the MENU but-
ton to clear the menu, then press the PLAY button.
If a tape is already in the TV/VCR with the power
off, do either of the following:
A) Press the PLAY button on the TV/VCR. Power
will automatically turn on and playback will start.
B) Press the POWER button on the remote control to
turn the TV/VCR on, then press the PLAY button
on the remote control and playback will start.
3 To stop playback
Press the STOP button when play-
back is completed.
INSERTING A CASSETTE
Insert the cassette in the direction as shown. Push in
gently, but continuously, on the center-back of the
cassette until it is drawn into the TV/VCR. The
TV/VCR will automatically turn on.
CORRECT
Window
WRONG
This TV/VCR will operate with any cassette that has the mark. For best results, we
recommend the use of high-quality tapes. Do not use poor quality or damaged tapes.
PLAY
B
STOP
PRECAUTIONS
Avoid moisture. Moisture condensation may occur
on the tape if it is moved from a cold place to a
warm place or visa versa. Before using a tape with
these conditions, to avoid damage of the tape and
your TV/VCR, wait until the tape has warmed to
room temperature and the moisture has evaporated.
Avoid extreme heat, high humidity and magnetic
fields.
Do not tamper with the cassette mechanism.
Do not touch the tape with your fingers.
FM MODE (SRC21134 only)
This function enables you to receive FM radio broad-
casting.
1 Set the FM mode
Press the TV/FM button on the
remote control. The radio frequency
appears on the TV screen.
2
Select the radio frequency you want to receive
Press the CHANNEL K or L button until your
desired radio frequency appears.
FM 88.0 MHz
NOTES:
FM mode is not available for model SRC21194.
The radio frequency indication repeats to appear
and disappear.
You can not record the FM radio wave broadcast-
ing.
If you receive a weak radio signal, you may change
the FM Antenna mode to INT(internal) or
EXT(external) by following the step below.
1)Press the MENU button. Press the PLAY/K or
STOP/L button to point to “CHANNEL SET UP”.
Then, press the F.FWD/B button.
2)Press the PLAY/K or STOP/L button to point to
“FM ANTENNA”. Select [INT] or [EXT] using
the F.FWD/B or REW/s button.
T5215 _VA 01.2.21 7:13 PM Page 17