Filter
Top Products
•
Shaded buttons are used for following operation.
1 Plug the power cord into a standard
AC outlet.
•
If any digits are displayed in the corner of the
screen, press [POWER] without unplugging
the power cord.
2 Press [POWER] to turn on the unit.
3 Use [CH. K /L] to select the desired channel
number.
or
Use the Number buttons to enter the desired
channel number.
For channel number selection with number
buttons:
•
To select single-digit channel number, press
[0]
first. (e.g. Press [0] [2] for channel 2.)
•
To select cable channels which are higher
than 99, press [+100/+10] first.
(e.g. Press [+100/+10] [2] [5] for channel 125.)
4 Use [VOL.
XX
/
YY
] to select the desired volume
level.
•
Press [MUTE] to instantly mute the sound.
Press it again to restore the previous volume
level.
•
If you use [CH. K /L] in the DVD mode,
you can change the TV channels. Even if you
turn off the unit in the DVD mode, when you
turn it on again, it will go into the TV mode.
TO WATCH CABLE OR SATELLITE
CHANNEL
If the unit is connected to a cable box or satellite
box, use [CH. K /L] to select CH3 or CH4 accord-
ing to the output channel setting of the device and
select desired channel on that device.
TO WATCH EXTERNAL INPUT
When an external equipment is connected to the front
AUDIO/VIDEO input jacks, press [SELECT] or
[CH. K /L] repeatedly until “VIDEO1” or
“VIDEO2” appears on the screen.
•
If a disc is inside the unit, “DISC INSIDE” mes-
sage is displayed on the screen for 10 seconds.
•
To clear the message instantly, press [CLEAR].
- 12 - EN- 12 - EN- 12 - EN- 12 - EN- 12 - EN- 12 - EN- 12 - EN- 12 - EN- 12 - EN
TV OPERATION AND SETTINGS
WATCHING A TV PROGRAM
VOLUME 20
C C C C C C C C C C C C C C C C
TV SECTION
REV
SLOW
PLAY
STOP
FWD
ENTER
PAUSE
DISC
MENU
RETURNTITLESETUP
DISPLAY
SKIP
SELECT
POWER PICTURE
EJECT
CH.
VOL.
MUTEZOOM
SLEEP
123
456
789
0 +10
+100
CH.
POWER
123
456
789
0 +10
+100
VOL.
NOTE
NOTE
NOTE
NOTE
DISC INSIDE