Filter
Top Products
EN - 14 -
You can view specially labeled (cc) TV programs,
movies, news and pre-recorded tapes with either a
dialogue caption or text display.
CAPTION mode: You can watch dramas, movies and
news while captioning the dialogues and the contents
of news.
TEXT mode: You can watch half screen text informa-
tion if you want.
1-2: You may get these captions or text information
by selecting either “1” or “2”. “2” is usually used for
a second language if available.
•
Not all programs are broadcast with closed cap-
tions. Your unit is designed to provide error-free
closed captions from high quality antenna, cable
and VCR signals. Conversely, poor quality sig-
nals are likely to result in caption errors or no
captions at all. Common signal conditions which
may cause caption errors are listed below:
–
Automobile ignition noise
–
Electric motor brush noise
–
Weak snowy reception on TV screen
–
Multiplex signal reception displaying picture
ghosts or airplane flutter
•
If the unit displays a black box on the TV
screen, this means that the unit is set to the
TEXT mode. To clear screen, select
“CAPTION1”, “CAPTION2” or “OFF”.
1 Press [SETUP] then press [K] or [L] to point
to “CAPTION”.
2 Press [ENTER] repeatedly to select the
desired caption menu “CAPTION1”,
“CAPTION2”, “TEXT1” or “TEXT2”.
•
If you select “OFF”, Closed Caption System set-
ting is canceled.
3 Press [SETUP] to exit the menu.
•
Even if there is a power failure of any
kind, the unit will retain its memory for
this feature.
TO SELECT TV SOUND MODE
1 Press [AUDIO] repeatedly to select the MTS
output mode.
•
The output mode changes as described below
every time you press [AUDIO].
* Second Audio Program (SAP):
Sometimes broadcasters add another channel of
audio to the programs they air. This is usually a
secondary language or perhaps a radio station.
•
After 5 seconds, the current audio status will
disappear from the TV screen.
•
The initial setting is “STEREO”.
•
This setting is saved even if the unit is turned
off or the AC cord is unplugged.
TO CHECK THE SOUND STATUS
By pressing [DISPLAY], the status shown below
will appear on the display when you receive a broad-
cast on the unit tuner channel you are watching.
1) When a program is broadcast in stereo,
“STEREO” appears on the TV screen.
2) When a program is broadcast in second audio,
“SAP” appears on the TV screen.
3) When a program broadcast both in stereo and sec-
ond audio, “STEREO/SAP” appears on the TV
screen.
CLOSED CAPTION SYSTEM
- TV SET UP -
CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
B CAPTION [OFF]
BACK LIGHT [BRIGHT]
- TV SET UP -
CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
B CAPTION [CAPTION1]
BACK LIGHT [BRIGHT]
SETUP
ENTER
SETUP
MTS (Multi-Channel Television
Sound) System
AUDIO
NOTE
NOTE
STEREO
SAP
*
MONO
NOTE
STEREO
CH 123
STEREO/SAP
3)
1)
2)