Filter
Top Products
5
1. Press the PSET (PRESET ON/OFF) button on the front panel. The current band and
channel position will be displayed on screen (in green).
2. Press AUTO (AUTO PRESET) button, the appliance will search the signal of TV station in
the order of VHFL, VHFH and UHF, as shown in the following, and memorise them from
channel number 1 position.
* During presetting, the green block turns into yellow.
The moving red block indicates the change of tuning voltage.
3. When presetting is over, the channel position is set to number 1 automatically.
4. Press PSET (PRESET ON/OFF) button to exit preset mode.
NOTE: During presetting, auto presetting will be cut off if any one of STAND BY button,
PRESET ON/OFF button or AUTO PRESET button is pressed.
MANUAL TUNING
1. Press PSET (PRESET ON/OFF) button to set preset mode.
2. Select a channel position.
* If “SKIP” displays on the screen, press "SKIP" button on the front panel to exit "SKIP"
mode.
CHANNEL PRESET
AUTO PRESET
.
6
15
UHFVHFL
VHFH
.
* PREVIOUS BUTTON (REMOTE CONTROL UNIT)
Pressing this button to select the channel that was tuned immediately before the one being
watched. For example: If you are watching the program on channel 6, and the previous
program you watched is on channel 15; then you can press the button to reach channel 15,
press it again to return channel 6.
3. Press and hold MANUAL TUNING button until your desired program appears.
llllllllllllll
8 SKIP
SKIP
llllllllllllll
8 VHFH
UHF
UHF
VHFH
VHFH
VHFL
VHFL
MFT
NOTE: To select two digit channel, the second digit must be pressed within 2 seconds.