Panasonic AJ-HD3700BP VCR User Manual


 
- 13 -
2K error messages
Error messages in the 2K system mode are added. In the event of an abnormal condition, an error message is
displayed in the window of the unit. In this case, follow any instructions included in the description.
If any errors are generated, the front LED (ALARM, 2048 or 1920) of the AJ-HDP2000 lights or blinks (at normal
speed or high speed).
Message Error description
AJ-HDP2000
ALARM LED
2048 or 1920
LED
2K FAN STOP The fan for the AJ-HDP2000 stops.
(Contact the nearest dealer.)
2K NO REMOTE Rear SERVICE SW of the AJ-HDP2000 is not in
the OFF position.
RECORDED FORMAT UNMATCH (NO J2K TAPE) TAPE is not compressed in J2K format.
RECORDED FORMAT UNMATCH There is a mismatch between SYSTEM
FORMAT of the unit selected in settings and
FORMAT of TAPE. (2048/1920, XYZ/RGB)
RECORDED RATE UNMATCH OUTPUT FRAME
FREQUENCY
There is a mismatch between the output frame
frequency and the frame frequency recorded on
the tape.
CONCEAL V IN 2K An error occurs in 2K reproduction data and
the CONCEAL function works.
NO SERIAL DATA INPUT FROM HDD5 Compressed SERIAL DATA (HD SDI) from
AJ-HD3700B/A/H main unit is not linked.
NO 2K FORMAT SERIAL DATA INPUT In 2K SYSTEM mode, the compressed SERIAL
DATA from AJ-HD3700B/A/H main unit is not a
J2K compression signal.
CRC ERROR IN SERIAL DATA INPUT FROM
HDD5
A CRC error occurs in SERIAL DATA (HD SDI)
signals from AJ-HD3700B/A/H main unit to
AJ-HDP2000.
NO EXTERNAL HD REF IN 2K HD REF IN is not connected.
Signals other than 1920 a 1080 (HD) tri-level
sync signal are transmitted to HD REF IN.
* If any warnings are generated while ERR/FMT or ERR are set in TC/CHR menu F13
(EX SUPER), “2K PROC ERROR” is displayed on SUPER of the Monitor OUT output.
: Lighting
: Fast Flashing
: Flashing
: Flashing with some setting
F13
F12
F11
F10
F9
F8F7F6F5F4F3F2F1